Aluminium alloy 6262 is a heat treatable alloy with very good corrosion resistance and strength. Additions of bismuth to the alloy mean that 6262 has excellent machinability and surface finish.
High-speed steel or carbide tooling can be used to obtain smooth finishes. Heavy cutting requires oil lubricant but light cutting can be done dry.
Alloy 6262 can be used in place of 2011 when higher corrosion resistance and better anodising response is required.
Applications
6262 is commonly used in the manufacture of:
Screw machine products
Camera parts
Nuts
Couplings
Marine fittings
Decorative hardware and appliance fittings
Hinge pins
Oil line fittings
Valves and valve parts
PLEASE NOTE: Due to European Environmental Protection Directives:
# 2000/53/CE-ELV – For the automotive sector
# 2002/95/CE-RoHS – For the electrical and electronics sector
This alloy has been replaced by Alloy 6026 which has a lower Lead content.
Alloy Designations
Aluminium alloy 6262 also corresponds to the following standard designations and specifications but may not be a direct equivalent:
AA6262
Al 1.0Mg 0.6Si Pb
A96262
PLEASE NOTE: Due to European Environmental Protection Directives:
# 2000/53/CE-ELV – For the automotive sector
# 2002/95/CE-RoHS – For the electrical and electronics sector
This alloy has been replaced by Alloy 6026 which has a lower Lead content.
Temper Types
The most common tempers for 6262 aluminium are:
- T9 - Solution heat treated, artificially aged and cold worked
- T6 - Solution heat treated and artificially aged
Weldability
Alloy 6262 is readily weldable by all commercial methods and can also be brazed.
Weldability – Gas: Excellent
Weldability – Arc: Excellent
Weldability – Resistance: Excellent
Brazability: Excellent
This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.
Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.
The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed & online) and manufacturers’ data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources.
Material supplied by the Company may vary significantly from this data, but will conform to all relevant and applicable standards.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied.
Advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. All transactions are subject to the Company’s current Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.